CHAPTER 12 MAINTENANCE PROCEDURES AUXILIARY POWER UNIT (APU)

HYDRAULIC ACTUATOR REPAIR (CONTINUED) - TM-9-2350-267-34_271

TM-9-2350-267-34 Hull Powerpack Drive Controls Tracks Suspension and Associated Components Carrier Ammunition Tracked Manual
Page Navigation
240

CHAPTER 12 MAINTENANCE PROCEDURES AUXILIARY POWER UNIT (APU) CHAPTER OVERVIEW This chapter illustrates and describes repair procedures for: Section I APU Starter/Generator Brushes Section II APU Chain Cover Section III APU Gear Case Section I APU STARTER/GENERATOR BRUSHES APU STARTER/GENERATOR BRUSHES: REPAIR These procedures apply to both brushes in any one of six brush sets. Note position of dust cover band before remova1 to ensure proper installation. REMOVAL A Remove and discard lockwire (1). B Remove guard band latch screw (2), push back dust cover band (3) and remove brush guard (4). C Remove screw (5) and lead wire (6). NOTE A screwdriver or stiff piece of wire bent into shape of a hook (7) maybe used in step D. D Carefully pull or pry brush retainer springs (8) up far enough to clear brushes (9) and remove brushes (9). 12-1 Change 4 TM 9-2350-267-34

Privacy Statement
Press Release
Contact