ASSEMBLY - TM-9-2350-267-34

HYDRAULIC ACTUATOR REPAIR (CONTINUED) - TM-9-2350-267-34_268

HYDRAULIC ACTUATOR REPAIR (CONTINUED) - TM-9-2350-267-34_270

TM-9-2350-267-34 Hull Powerpack Drive Controls Tracks Suspension and Associated Components Carrier Ammunition Tracked Manual
Page Navigation
237

HYDRAULIC ACTUATOR REPAIR (CONTINUED) C Install piston head (5) on piston rod (3). D Install washer (6) on piston rod (3). E Coat threads on piston head (5) end of piston rod (3) with grease (item 59, Appx B). CAUTION When clamping piston rod in vise, make sure threads, piston and finished surface of rod are not clamped. Damage to rod or piston could result. Always use shop cloths to protect clamped parts. NOTE An assistant is required to restrain piston rod during nut installation. F Clamp flatted end (7) of piston rod (3) in vise. Ensure threaded portion of rod is protected from damage. Install nut (8) on piston rod (3). NOTE ASSEMBLY Make sure washer (6) is flat against recess in A Install new packing (1) and two new retainers (2) on piston piston head (5). rod (3). G Torque nut (8) to 250-280 lb-ft. B Install washer (4) on piston rod (3) with chamfer side of washer (4) toward piston head (5). H Install new piston T-seal (9) and two retainers (10) in piston (5). TA309855 11-19 TM 9-2350-267-34

Privacy Statement
Press Release
Contact