HYDRAULIC CLUTCH REPAIR (CONTINUED)

HYDRAULIC CLUTCH REPAIR (CONTINUED) - TM-9-2350-267-34_258

HYDRAULIC CLUTCH REPAIR (CONTINUED) - TM-9-2350-267-34_260

TM-9-2350-267-34 Hull Powerpack Drive Controls Tracks Suspension and Associated Components Carrier Ammunition Tracked Manual
Page Navigation
227

11-9 HYDRAULIC CLUTCH REPAIR (CONTINUED) G Remove snapring (13) from shaft (2). H Remove snapring (14) from body (8). I Remove assembled shaft (2) and body (8) from pressure ring (15) and housing (16) by tapping out with a hammer and a brass drift if necessary. J Separate shaft (2) from body (8) with press. Remove key (17). K Place housing (16) with pressure ring (15) face down. Use a compressed air source to apply low pressure through inlet port of housing (16). Remove assembled pressure ring (15) and piston (18) from housing (16). WARNING Compressed air used for cleaning purposes will not exceed 30 psi. Use only with effective chip guarding and personal protective equipment (goggles, shield, gloves, etc.). TA309845 TM 9-2350-267-34

Privacy Statement
Press Release
Contact