ROADWHEEL ARM ASSEMBLY - UPPER SPINDLE REPAIR (CONTINUED)

ROADWHEEL ARM ASSEMBLY - UPPER SPINDLE REPAIR (CONTINUED) - TM-9-2350-267-34_178

ROADWHEEL ARM ASSEMBLY - UPPER SPINDLE REPAIR (CONTINUED) - TM-9-2350-267-34_180

TM-9-2350-267-34 Hull Powerpack Drive Controls Tracks Suspension and Associated Components Carrier Ammunition Tracked Manual
Page Navigation
152

ROADWHEEL ARM ASSEMBLY - UPPER SPINDLE REPAIR (CONTINUED) K Refer to TM 9-214 for inspection of outer bearing with race (10). P Inspect bearing spacer (11) for damage or distortion. Replace if damaged or distorted, or if ends are not parallel within 0.0010 inch. L Check OD (A) of bearing. OD (A) of new part is 4.6242-4.6250 inches. Q Check ID of seal counterbore (C) of retainer (12). ID (C) of new part is M Check fit of bearing in housing. New part fit is 0.0005L-0.0028L. 5.6200-5.6220 inches. Wear limit is 5.6240 inches. N Check race ID (B). ID (B) of new part is 3.7492-3.7500 inches. R Check OD of shoulder (D). OD (D) of new part is 4.6220-4.6240 inches. Wear limit is 4.6180 inches. O Check fit of race on spindle. New part fit is 0.0003L-0.0015L. TA309805 7-17 TM 9-2350-267-34

Privacy Statement
Press Release
Contact