References:7-44Change 4TM 9-2350-267-20STEERING CONTROL LINKAGE: ADJUSTMENTINITIAL SETUPADJUSTMENTNOTETM 9-2350-267-10l All adjustment to the steering linkage must result withsteering shaftrod lever (11) in neutral position (pointeron transmission steering shaft points to center position).l Steering wheel (1) must return to normal “forward”position (center spoke vertical).l Quick disconnect pins (3) should easily insert throughsteering rod ends.A Turn steering wheel (1) full left and hold. Check for contact between rod end(2) and bottom of hole through bulkhead. If there is no contact proceed tostep E.BRemove two quick release (3), two bolts (12) and lockwashers (13) fromcover plate (14) and rod assembly (4).C Loosen two nuts (5) and adjust rod ends (2) to lengthen rod assembly (4).D Tighten nuts (5) and install rod assembly (4). Return to step A.E Turn steering wheel (1) full right and hold. Check for contact between rodend (2) and top of hole through bulkhead. If there is no contact proceed tostep H.FRemove two quick disconnect pins (3), two bolts (12) and lockwashers (13)from cover plate (14) and rod assembly (4).G Loosen two nuts (5) and adjust rod ends (2) to shorten rod assembly (4).Return to step E.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
