HAND THROTTLE CONTROL ROD AND ACCELERATOR PEDAL

ENGINE THROTTLE GOVERNOR CONTROL ROD: ADJUSTMENT

TM-9-2350-267-20 Carrier Ammunition Tracked M992 (2350-01-110-4660) Manual
Page Navigation
764

HAND THROTTLE CONTROL ROD AND ACCELERATOR PEDAL: ADJUSTMENT ADJUSTMENT A B C D E F G H I J K L M Open and secure driver’s hatch. NOTE l 1/4-inch dowel may be used. l Dowel fits through lever and into bulkhead pilot hole. Insert 1/4-inch diameter dowel pin into positioning hole (1) on throttle lever cover (2). Remove cotter pin (3) and clevis pin (4) from throttle lever (5). Discard cotter pin. Remove control rod (6) from throttle lever (5). Insert 1/4-inch diameter dowel pin into positioning hole (7). Loosen locknut (8). Adjust rod end (9) until clevis pin (4) can be inserted easily. Tighten locknut (8). Install rod (6), new cotter pin (3) and clevis pin (4). Remove dowel pins in positioning holes (1 and 7). Start engine with throttle control closed. Check tachometer. Engine should be at idle speed (650 rpm). Close driver’s hatch. TA57236 7-47 Change 2 TM 9-2350-267-20

Privacy Statement
Press Release
Contact