6-56
TM 9-2350-267-20
NATO INTERVEHICLE SLAVE CONNECTOR: REMOVAL AND INSTALLATION
REMOVAL
A
B
C
D
E
WARNING
Turn OFF MASTER switch. Disconnect battery
ground cables.
NOTE
The following procedures apply to both bat-
tery compartment and rear plate mounted
intervehicle slave connectors.
Pull back rubber boot (1) to expose electrical leads (2).
Disconnect two electrical leads (2) from connector (3) by
removing from each lead, one screw (4) and one lockwasher (5).
Remove rubber boot (1).
Pull off cover (6) from connector (3).
For rear NATO receptacle, remove four screws (7) and four
lockwashers (8) that secure cord (9) and connector (3) to hull
rear plate (10).
or
For battery compartment NATO receptacle, remove four
screws (7), four nuts (11), four lockwashers (12), four flat
washers (13) and cord (9) from rear plate (10).
INSTALLATION
Reverse removal procedures.
TA311087
