6-52
Change 1
TM 9-2350-267-20
AIR CLEANER BLOWER MOTORS: REMOVAL AND INSTALLATION
INITIAL SETUP
References:
TM 9-2350-267-10
CREW COMPARTMENT
(HULL FORWARD BULKHEAD)
REMOVAL
A Move right projectile rack to rear of vehicle (TM 9-2350-267-10).
B
Disconnect two electrical leads (1) and two ground leads (2).
C Loosen four clamps (3) by turning four screws (4).
D Disconnect four hoses (5) from blower motors (6).
E
Loosen two clamps (7) by turning two screws (8).
F
Pull two blower motors (6) out of two clamps (7) and remove.
G
Remove two clamps (7) by removing from each; two screws (9),
two lockwashers (10) and gasket (11). Discard lockwashers and
gaskets.
INSTALLATION
A
Install two clamps (7) with new gasket ( 11), two screws (9) and
two new lockwashers (10).
B
Install two blower motors (6) in two clamps (7) and secure by
tightening two screws (8).
C
Connect four hoses (5) to blower motors (6).
D Tighten four clamps (3) by turning four screws (4).
E
Connect two ground leads (2) and two electrical leads (1).
F
Move right projectile rack to front of vehicle (TM
9-2350-267-10).
TA312801
