HAND THROTTLE CONTROL ROD AND ACCELERATOR PEDAL: ADJUSTMENT (CONTINUED)ACCELERATOR PEDAL: ADJUSTMENTABCDEnsure hand throttle control adjustment is correct (p 2-76).Loosen jam nut (1) and then turn adjusting screw (2) complete-ly in.Depress accelerator pedal (3) until it stops. Hold pedal downand turn adjusting screw (2) until it touches the acceleratorpedal.Tighten jam nuts (1).SERVICE AND PARKING BRAKE LINKAGE: ADJUSTMENTSERVICE BRAKE: ADJUSTMENTA Release service brake. Check for slack in the sprocket controlchain (1). If no slack is present, go to step B. If slack is pre-sent, remove cotter pin (2) and clevis pin (3) from brake shaftlever (4). Loosen locknut (5) and turn rod (6) clockwise toshorten. Replace pin (3) and check for slack again. If slack isstill present, repeat the above. If no slack, go to step B.TA3104362-77TM 9-2350-267-20
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business