HAND THROTTLE CONTROL ROD AND ACCELERATOR PEDAL

HAND THROTTLE CONTROL ROD AND ACCELERATOR PEDAL (cont)

TM-9-2350-267-20 Carrier Ammunition Tracked M992 (2350-01-110-4660) Manual
Page Navigation
159

2-76 Change 1 TM 9-2350-267-20 ENGINE ENGINE DOESN’T ACCELERATE PROPERLY 2 3 4 Run STE/ICE Test No. 13 (p 2-48.10). a If test passes, go to step2. b If test fails, notify Supprtt Maintenance. Run STE/ICE Test No. 24 (p 2-48.15). a If test passes, go to step3. b. If test fails, replace fuel pump and verify no faults. Check brake adjustment (p 2-77 and 7-40). conduct fuel flow test (p 4-22). HAND THROTTLE CONTROL ROD AND ACCELERATOR PEDAL: ADJUSTMENT HAND THROTTLE CONTROL ROD: ADJUSTMENT A Insert dowel pin (0.225-inch diameter) in positioning hole (1) of throttle lever cover (2). Remove cotter pin (hidden) and clevis pin(3) and remove control rod (4) from throttle lever (5). Insert dowel pin (0.225-inch diameter) in positioning hole (6) in throttle lever and bulkhead. C Loosen nut (7) and adjust rod length until clevis pin (3) can be easily inserted through rod end (8). Install clevis pin (3) and cotter pin (hidden). Tighten nut (7). D Start engine with throttle control closed. Engine should be at idle speed (650 rpm). TA312691

Privacy Statement
Press Release
Contact