NBC POWER CONTROL BOX: REMOVAL. DISASSEMBLY AND INSTALLATION (CONTINUED)ABCDEFGInstall mounting plate (29) with four new lockwashers (52) and fourmounting screws (51).Install connector J2 (50) and new gasket (49) with four screws (46), four newlockwashers (48) and four nuts (47).Install connector J1 (44) and new gasket (43) on control box body (45) withfour screws (40), four new lockwashers (42) and four nuts (41).Install circuit breaker (10) on mounting plate (29) with two mounting screws(38) and two new lockwashers (39).Install relay (7) and two ground wires (28) on mounting plate (29) with twomounting screws (26) and two new lockwashers (27).Install two wires (36 and 37) on circuit breaker terminal A with one hexscrew (34) and new lockwasher (35).Install two wires (32 and 33) on relay (7) terminal A1 and circuit breaker (10)terminal B. Install hexnut (30) and new lockwasher (31) on relay (7) terminalA1.HIJKLMNOInstall five wires (25) on relay (7) terminal A2 with hexnut (23) and newlockwasher (24).Install switch (15) and guard (22) on front cover (3) with panel hexnut (20)and washer (21).Install boot (19) on switch (15).Install lamp assembly (16) on front cover (3) with panel hexnut (17) andwasher (18).Hold front cover (3) and new gasket (4) in a tilted position over control boxbody (45).Connect wire (14) to circuit breaker terminal B and install hex screw (8)and new lockwasher (9).Connect two wires (11 and 12) to relay (7) terminal X-1 and wire (13) to relay(7) terminal X-2. Install two hexnuts (5) and two new lockwashers (6).Install new gasket (4) and front cover (3) with ten screwslockwashers (2).(1) and ten new14-11Change 4TM 9-2350-267-20
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
