M43 DETECTOR MOUNT AND BRACKETS (VEHICLES 378 AND ABOVE): REMOVAL AND INSTALLATION
NOTE
Refer to TM 3-6665-225-12 for organizational
maintenance instructions on M43 detector unit.
REMOVAL
A Disconnect connector (1) of power cable (2) at wall-mounted bracket (3).
B Remove two nuts (4), two lockwashers (5), two screws (6) and two flat
washers (7). Discard lockwashers.
C Remove two nuts (8), two lockwashers (9), two screws (10) and two flat
washers (11) from bracket (12) and remove mount (13) and bracket (12) as
an assembly. Discard lockwashers.
D Remove bracket (14) by removing three nuts (15), three lockwashers (16),
six flat washers (17) and three screws (18). Discard lockwashers.
E
Remove bracket (12) from mount (13) by removing four nuts (19), four
lockwashers (20) and four screws (21). Discard lockwashers.
14-12.3/(14-12.4 blank)
Change 4
TM 9-2350-267-20