APU CONTROL BOX: DISASSEMBLY, ASSEMBLY, CIRCUIT TEST AND INSTALLATION (cont)

APU CONTROL BOX: DISASSEMBLY, ASSEMBLY, CIRCUIT TEST AND INSTALLATION (cont) - TM-9-2350-267-20_1213

APU CONTROL BOX: DISASSEMBLY, ASSEMBLY, CIRCUIT TEST AND INSTALLATION (cont) - TM-9-2350-267-20_1215

TM-9-2350-267-20 Carrier Ammunition Tracked M992 (2350-01-110-4660) Manual
Page Navigation
1117

13-38 TM 9-2350-267-20 APU CONTROL BOX: REMOVAL, DISASSEMBLY, ASSEMBLY, CIRCUIT TEST AND INSTALLATION (CONTINUED) F Remove engine oil pressure gage bracket (13) by removing two nuts (14) and two lockwashers (15) from rear of gage box. G Remove ENGINE OIL PRESSURE gage (16) from front of control box. H Remove FUEL SHUTOFF switch (17), APU GENerator switch (18), PREHEAT switch (19) and START switch (20) by removing from each, two screws (21), two lockwashers (22) and one guard (23). I Remove LOW OIL PRESSure and HIGH AIR Temperature lights (24) by removing from each, two screws (25) and two lockwashers (26). ASSEMBLY A Reverse disassembly procedures. B For wiring harness installation/connection use diagram on p 13-35. TA309984

Privacy Statement
Press Release
Contact