APU COMPARTMENT SOUNDPROOF PANELS: REMOVAL AND INSTALLATION
REMOVAL
NOTES
To remove rear panel remove: APU fuel filters
(p 13-16), hydraulic pressure switch (p 13-17),
APU ground lead (p 13-1) and hydraulic lines and
elbows (p 13-1).
To remove right side panel remove: APU fuel
lines and elbows (p 13-26).
The following procedures apply to all soundproof
panels in APU compartment. Do not remove
APU to replace APU door soundproof panel.
A Remove APU from vehicle (p 13-1).
B
Pull and scrape defective panel off interior wall or side door
of APU compartment.
C Thoroughly clean adhesive from wall or door area with dry-
cleaning solvent (item 19, Appx D) and clean, dry rags (item
50, Appx D). Be sure to remove all particles.
INSTALLATION
A
Apply thin coat of adhesive (item 4, Appx D) to back
(smooth, non-matted) side of soundproof panel.
B Allow adhesive to dry until tacky.
C Mount panel to wall or door panel.
NOTE
For best installation results, pressure should be
applied evenly to all outside surfaces.
TA309979
13-33
TM 9-2350-267-20