13-32.2
Change 1
TM 9-2350-267-20
APU PANEL SUPPORTS: REMOVAL, DISASSEMBLY, ASSEMBLY AND INSTALLATION
REMOVAL
A Remove APU (p 13-1).
B
Remove support (1) by removing two screws (2), two
lockwashers (3) and two flat washers (4).
C Remove support (5) by removing two screws (6), two
lockwashers (7) and two flat washers (8).
D Remove support (9) by removing two screws (10), two
lockwashers (11) and two flat washers (12).
DISASSEMBLY
A
Remove three hook-and-pile tape sections (13) from sup-
ports (1, 5 and 9) and one hook-and-pile tape section (14)
from vehicle front plate using a suitable scraper.
B
Thoroughly clean support and front plate surfaces with
dry-cleaning solvent (item 19, Appx D) and clean, dry rags
(item 50, Appx D).
ASSEMBLY
A
Apply thin coat of adhesive (item 6, Appx D) to mounting
surface of supports (1, 5 and 9) and front plate (14). Allow to
dry until tacky.
B
Install pre-coated hook-and-pile tape sections on supports
and front plate.
INSTALLATION
Reverse removal procedures.
TA309978