12-44
Change 2
TM 9-2350-267-20
HYDRAULIC MOTOR AND DRIVE SPROCKET: REMOVAL AND INSTALLATION (CONTINUED)
INSTALLATION
A
Install new packing (16).
B
Install brake (13) on motor (5) with two screws (14) and two new
lockwashers (15).
NOTE
Apply Teflon tape (item 62, Appx D) to all male
pipe threads prior to installation.
C
D
E
F
G
H
I
J
Install two adapters (12), two adapters (11) and two elbows (2)
on motor (5).
Install motor (5) on support bracket (10) with four screws (7),
four new lockwashers (8) and four flat washers (9).
Install key (6) in shaft of motor (5).
Install sprocket (4) on shaft of motor (5), hub side first, alining
key (6) to slotted groove.
Tighten setscrew (3).
Connect three hydraulic lines (1) to three elbows (2).
Check hydraulic fluid level in reservoir and add if necessary (LO
9-2350-267-12).
Activate APU and operate stacker controls to check motor
operation (TM 9-2350-267-10).
TA57486
