TM 9-2350-267-10
PORTABLE INSTRUMENT PANEL CHECKOUT PROCEDURE
Frequently check the following gages and indicators to make sure vehicle power
pack continues to operate correctly. If the following normal indications are not
observed during this check, refer to troubleshooting section in Chapter 3.
Troubleshooting procedures begin on page 3-5.
1. MASTER WARNING lamp (1) should go out after engine has run for 15 seconds.
CAUTION
If the MASTER WARNING lamp lights during operation, im-
mediately check TRANSMISSION OIL TEMPERATURE
gage, ENGiNE WATER TRANSMISSION gage, and ENGiNE
OIL PRESSURE gage (steps 4,5,6, and 7, respectively) for
readings in the normal ranges. if gage readings are correct,
but iamp stays lit, notify Organizational Maintenance.
2. COOLANT level indicator lamp (2) should be OFF.
2-86
