TM 9-2350-261-34
REPAIR TENT INTERFACE PANEL BOX ASSEMBLY A5
(M1068 ONLY)
DESCRIPTION
This task covers:
Disassemble (page 21.1-47).
Clean, Inspect, and Repair (see Chapter 2).
Assemble (page 21.1-50).
INITIAL SETUP
Tools:
General Mechanic’s Tool Box
(Item 35, App B)
Electronic Equipment Tool Kit
(Item 94.1, App B)
Materials/Parts:
Adhesive (Item 1, App C)
Lockwasher (14)
Self-locking nut (30)
Personnel Required:
Power-Generation Equipment Repairer 52D10
Radio Repairer 29E10
References:
See your -10
See your -20
Equipment Conditions:
Tent interface panel box assembly removed
(see your -20)
DISASSEMBLE
3.
1. Remove 14 screws (1), lockwashers (2), and
faceplate (3) from box (4). Discard
lockwashers.
NOTE
4.
Do not remove gasket unless gasket is
damaged.
5.
2. If any of four gaskets (5) are damaged,
remove only the damaged gaskets from
box (4).
NOTE
Tag all leads before disconnecting from
connectors. Use wiring diagram
(page 21.1-49).
Remove four locknuts (6), screws (7), connec-
tor (8) and gasket (9) from box (4). Discard
locknuts.
Remove four locknuts (10), screws (11), dust
cap (12), connector J137 (13), and
gasket (14) from faceplate (3). Discard
locknuts.
Disconnect four leads (15) from four binding
posts (16).
GO TO NEXT PAGE
Change 4
21.1-47
