TM 9-2350-261-34
LEFT REAR FENDER WELDMENT
(EXCEPT M106A2 AND M125A2)
NOTE
Weld left rear fender as shown (except
M106A2 and M125A2). Right side is the
opposite and is welded accordingly.
4.
LEft REAR FENDER WELDMENT
(M106A2 AND M125A2 ONLY)
NOTE
Weld left rear fender as shown (M106A2
and M125A2 OnIy).
Clean all bare metal and paint per
TM 43-0139.
NOTE
If front splash guard was replaced, install
drive sprocket on earner (see your-20). If
rear fender was replaced, install idler
wheel (see your -20).
FOLLOW-THROUGH STEPS
1. Connect track and adjust tension
(see your -10).
2. Install track shroud and covers on carrier
(See your -20).
3. Reconnect battery ground (see your -20).
END OF TASK
8-37
