I N S T A LL - TM-9-2350-261-34

TM-9-2350-261-34 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
128

TM 9-2350-261-34 WARNING Engine is heavy. Use a lift- ing device. Have helper (H) assist. 51. 52. Use a lifting device of at least 2000 lb (908 kg) capacity and sling (1) to lift engine. Remove two screws (2), key washers (3), cap (4), base (5), and rubber engine mount (6) from support (7). Discard key washers. N O TE Remove and retain trunnion mounts for M 1 2 5 A 2 , M 1 0 6 4 , a n d M 1 0 6 A 2 engines only. 53. Remove eight screws (8), washers trunnion mount (10) from engine. carrier (9), and I N S T A LL 54. Use a lifting device of at least 2000 lb (908 kg) capacity and sling (1) to lift new engine from shipping container. Block rear end of engine on level ground (page 3–2). CAUTION Parts installed in steps 56 thru 118 are not supplied with new engine. These parts must be retained from the old engine. NOTE Install retained trunnion mounts for M 1 2 5 A 2 , M 1 0 6 4 , a n d M 1 0 6 A 1 c a r r i e r engines only. 55. 56. 57. Apply a thin coat of antiseize compound to cleaned threads of two screws (2). Install trunnion mount (10) on engine. Secure with eight screws (8) and washers (9). Tighten screws to 55-60 lb (75-81 N.m) torque. Use torque wrench (item 105). Install base (5), rubber engine mount (6) and cap (4) on support (7). Secure with two screws (2) and new key washers (3). Tighten screws to 360-420 in-lb (41-47 N-m) torque. Use torque wrench (item 110). Block front of engine mount (page 3–2) with Wood blocks. 3-40 Change 2 5 8 .

Privacy Statement
Press Release
Contact