5.
6.
.7.
8.
9.
Remove seven screws (1), lockwashers (2),
washers (3), and guard (4) from hull interior
behind driver's hatch. Discard lockwashers.
Remove screw (5) and lockwasher (6) from
clamp (7) securing ground lead (8) to hull.
Discard lockwasher.
Remove clip (9) from
hull. Free up ground
clip.
wiring cradle (10) on
lead (8) from cradle and
Remove four screws (11), lockwashers (12),
and washers (13) securing receptacle (14) to
adapter (15) or hull. Discard lockwashers.
Push down on bushing (16) inserted into
adapter (15) or hull. Pull receptacle (14) up
far enough to expose screws (17) and
leads (8 and 18) attached.
10.
11.
TM 9-2350-261-20-2
Remove screw (17). lockwasher (19), and
circuit 6 lead (18) from positive (+) side of
post on receptacle (14). Discard lockwasher.
Remove receptacle (14) and bushing (16)
from hull. Remove screw (17), lockwasher
(19), and ground lead (8) from negative (–)
side of post on receptacle (14). Discard
lockwasher and bushing.
N O T E
Perform step 12 only if the receptacle is
mounted on an adapter (15).
12.
13.
If adapter (15) is used, remove four screws
(20), lockwashers (21), washers (22), adapt-
er (15) with bushing (16), and gasket (23)
from hull. Discard gasket, bushing, and lock-
washers.
Remove gasket (24) and plate insulator (25)
from adapter (15). Discard gasket.
GO TO NEXT PAGE
9-7
