TM 9-2350-261-20-2
INSTALL
N O T E
Steps 14 through 21 tell you how to install
the late model slave receptacles. Steps 22
through 24 tell you how to install the
early model slave receptacles.
Perform step 14 only if the receptacle is
mounted on an adapter (1).
14.
15.
16.
If adapter (1) is used, place new gasket (2)
and adapter (1) on hull. Secure with four
washers (3), four new lockwashers (4), and
screws (5) .
Install new bushing (6) in adapter (1) or in
hull.
Connect ground lead (7) to negative (-) side
of post on receptacle (8). Secure with screw
(9) and new lockwasher (10).
17.
18.
19.
20.
21.
Place plate insulator (11) and new gasket
(12) on adapter (1) or hull.
Insert ground lead (7) into bushing (6) far
enough to connect circuit 6 lead (13) to posi-
tive (+) side of post on receptacle (8). Secure
with screw (9) and new lockwasher (10).
Secure receptacle (8) with plate insulator
(11) and gasket (12) to adapter (1) or hull
with four screws (14), four new lockwashers
(15), and four washers (16).
Inside carrier, install ground lead (7) to
hull. Secure with screw (17) and new
lockwasher (18) to clamp (19).
Inside carrier, fit ground lead (7) into wiring
cradle (20). Secure with clip (21).
9-8