6. Remove adapter (1), elbow (2), screw (3),
two lockwashers (4), and ground lead (5)
from pump (6). Use adjustable wrench and
pipe wrench. Discard lockwashers. Reinstall
screw in pump.
INSTALL
7.
8.
9.
10.
Remove screw (3) and washer from new
pump (6). Discard washer.
Install ground lead (5) on pump (6). Secure
with two new lockwashers (4) and
screw (3).
Apply sealing compound to external threads
of elbow (2) and adapter (1).
Install elbow (2) and adapter (1) on pump
(6). Use pipe wrench and” adjustable wrench.
11. Cement new cushion (7) on bottom of pump
(6) with adhesive.
12. Install pump (6) in carrier.
N O T E
Do not tighten strap screws until all four
are installed.
13. Install strap (8) and ground lead (9) on hull
weldnuts. Secure with three new
lockwashers (10), screw (11), new key
washer (12) and screw (13). Bend tabs on
key washer.
14.
15.
TM 9-2350-261-20-2
Install strap (14) on hull weldnuts. Secure
with two screws (13) and new key washers
(12). Bend tabs on key washers.
Slide hose (15) on adapter (16). Secure with
16.
17.
18.
Install strainer (18) on hull weldnuts.
Connect lead (19) to bilge pump (6).
Secure strainer (18) to hull weldnuts with
two new lockwashers (20), and screws (21).
GO TO NEXT PAGE
16-3
clamp (17).
