R E P L A C E F R O N T B I L G E P U M P A N D S T R A I N E R

C H A P T E R 1 6 E L E C T R I C A L S Y S T E M M A I N T E N A N C E - B I L G E P U M P , W I R I N G A N D R E L A T E D C O M P O N E N TS

INSTALL - TM-9-2350-261-20-2_390

TM-9-2350-261-20-2 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
357

TM 9-2350-261-20-2 R E P L A C E F R O N T B I L G E P U M P A N D S T R A I N E R DESCRIPTION This task covers: Remove (page 16-2). Install (page 16-3). INITIAL SETUP Tools: Personnel Required: General Mechanics Tool Kit (Item 30, App D) Unit Mechanic Adjustable Wrench (Item 80, App D) Pipe Wrench (Item 86, App D) References: See your -10 Materials/Parts: Sealing compound (Item 46, App C) Equipment Conditions: Adhesive (Item 52, App C) Cushion (3) Engine stopped/shutdown (see your -10) Carrier blocked (see your -10) Key washer (3) Trim vane lowered (see your -10) Lockwasher (5) Hull front access cover removed (page 24-24) Lockwasher (2) Battery ground lead disconnected (page 13-2) REMOVE N O T E If only strainer is to be replaced, see steps 1. 2. 1, 2, 15, and 16. Disconnect lead (1) from bilge pump (2). Remove two screws (3), lockwashers (4), and strainer (5) from hull weldnuts. Discard lockwashers. 3. Remove screw (6), three lockwashers (7), and ground lead (8) from strap (9). Discard lockwashers. 4. Remove three screws (10), key washers (11), and two straps (9 and 12). Discard key washers. 5. Loosen clamp (13). Remove hose (14) from pump (2). 16-2

Privacy Statement
Press Release
Contact