TM 9-2350-261-20-2
72,
73.
74.
75.
76.
77.
Install rear main wiring harness (1) on
three cradles (2) in driver’s compartment.
Secure with three cradle clips (3).
If engine coolant heater is installed, connect
circuit 400A lead (4) to engine coolant
heater control box lead.
If personnel heater is installed, connect cir-
cuit 400 lead (5) to heater control box lead.
Attach cord, left in transverse beam (6), to
circuit 38 lead (7). Pull lead through tran-
sverse beam into personnel compartment.
Untie cord from lead.
Install new lockwashers (8), clamps (9), and
circuit 38 lead (7) on three weldnuts (10),
Secure with three screws (11).
Connect circuit 38 lead (7) to dome
light (12).
78.
79.
so.
81.
Install circuit 48 connector (13) on bracket
(14). Secure with four screws (15) and
nuts (16).
Connect circuit 48 lead ( 17) to capaci-
tor (1 S).
Install one cradle ( 19), two new lockwashers
(20 ), circuit 48 connector ground lead (21),
and capacitor ( 18) on weldnut (22). Secure
with screw (23).
Install rear main wiring harness (24) on
four cradles ( 19). Secure with four cradle
clips (25).
GO TO NEXT PAGE
12-115
