TM 9-2350-261-20-2
Remove nut (1), washer (2), and rubber
bushing (3) around harness (4) from
connector (5).
Remove connector (5) from hull.
Pull harness (4) through hole in hull top.
Leave connector (5), rubber bushing (3),
washer (2), and nut (1) on harness.
10. Remove screw (6), locknut (7), clamp (8),
and harness (4) from upper bilge tube
clamp (9). Discard locknut.
11. Remove two screws (10), lockwashers (11),
clamps (12), and harness (4) from two lower
bilge tube clamps (13). Discard lockwashers.
7.
8.
9 .
12-118.2 Change
