TM 9-2350-261-20-1
R E P L A C E C O M P A R T M E N T T O B U L K H E A D F U E L H O S E S , T U B E S ,
A N D F I T T I N G S ( M 7 4 1 A 1 O N L Y )
DESCRIPTION
This task covers:
Remove (page 6-98).
Install (page 6-99).
INITIAL SETUP
Tools:
General Mechanics Tool Kit (Item 30, App D)
Materials/Parts:
Sealing compound (Item 46, App C)
Wiping rag (Item 61, App C)
Personnel Required:
Unit Mechanic
References:
See your -10
Equipment Conditions:
Ramp lowered (see your -10)
Engine stopped/shutdown (see your -10)
Battery ground lead disconnected (page 13-2)
Power plant rear access panel removed
(page (24-27)
Floor plates removed (page 24-40)
Ammunition stowage containers removed
(page 24-199)
Fuel bladder drained (page 6-88)
1.
2.
3.
4.
5.
6. Remove two jamnuts and nipples (5) from
transverse beam.
WARNING
Fuel flowing over a metal
7. Remove 8 screws (8), 16 clamps (9), and fuel
surface
causes
static
hoses (3 and 4) from 8 weldnuts (10).
electricity. This will cause a
spark unless the surface is
grounded.
NOTE
Use wiping rag to wipe up any spilled fuel.
Tag hoses before removing.
Disconnect two quick disconnect coupling
halves (1) from two quick disconnect coupling
halves (2) inside power plant rear bulkhead.
Disconnect fuel supply hose (3) and fuel re-
turn hose (4) from two nipples (5) in
transverse beam.
Remove two quick disconnect coupling halves
(2) from two elbows (6).
Remove two elbows (6) from two tube
assemblies (7).
Remove two tube assemblies (7) from two
nipples (5).
6-98
R E M O V E
