TM 9-2350-261-20-1
35. Install two nipples (1) in transverse beam.
36. Connect fuel supply hose (2) and fuel return
hose (3) to two nipples (l).
37. Connect two tube assemblies (4) to two
nipples (1).
38. Connect two elbows (5) to two tube
assemblies (4).
39. Install two quick-disconnect fittings (6) on
two elbows (5).
40. Install fuel supply hose (2) and fuel return
hose (3) on seven weldnuts (7). Secure with
fourteen clamps (8), seven new Iockwashers
(9) and seven screws (10).
41. Secure guard (11) to hull with two washers
(12), screws (13), and one new locknut (14).
42. Connect two quick-disconnect fittings
(6 and 15) inside power plant bulkhead.
F O L L O W - T H R O U G H S T E P S
1. Fill fuel compartment (see your -10).
5. Install fuse stowage rack (page 24-186).
2. Connect battery ground lead (page 13-2).
6. Raise and lock ramp (see your -10).
3. Start engine (see your -10) Check for leaks.
7. Stop/shutdown engine (see your -10).
4. Install floor plates (page 24-38).
8. Install power plant rear access panel
(page 24-29).
END OF TASK
6-64
