TM 9-2350-261-20-1
REPLACE FUEL SUPPLY HOSES, TUBES, AND FITTINGS
(M1064 ONLY)
DESCRIPTION
This task covers:
Remove (page 6-48.3).
Install (page 648.6).
INITIAL SETUP
References
See your –10
Tools
General Mechanics Tool Kit (Item 30, App D)
Equipment Conditions
Engine stopped/shutdown (see your –10)
Materials/Parts
Carrier blocked (see your -10)
Sealing compound (Item 46, App C)
Ramp lowered (see your –10)
Wiping rag (Item 61, App C)
Battery ground lead disconnected (page 13-2)
Lockwasher (11)
Fuel tanks drained (page 6-28)
Lockwasher (8)
Power plant rear access panel removed
Strap (20)
(page 24-27)
Heater duct removed (page 29-47)
Personnel Required
Floor plates removed (page 24-38)
Unit Mechanic
REMOVE
1.
2.
3.
4.
WARNING
Fuel flowing over a metal
surface
causes
static
electricity. This will cause a
spark unless the surface is
grounded.
NOTE
Use wiping rags to wipe any spilled fuel.
Separate quick disconnect half (1) from quick
disconnect half (2) inside power plant rear
bulkhead.
Remove fuel supply hose (3) from nipple (4).
NOTE
Tag quick disconnect couplings before
removal.
Remove quick disconnect half (2) from
elbow (5).
Remove elbow (5) from tube assembly (6).
5. Remove tube assembly (6) from nipple (4).
6. Remove nut (7) and nipple (4) from tran-
sverse beam.
GO TO NEXT PAGE
Change 2
6-48.3
