TM 9-2350-261-20-1WARNINGDrycleaningsolventP - D - 6 8 0 istoxicandflammable. Wear protectivegoggles and gloves; use onlyinwell-ventilatedarea;avoid contact with skin,eyes, and clothes, and do not breathevapors. Keep away from heat or flame.Neven smoke when using solvent; theflash point for Type I is 1000F (380C) andfor Type II is 138°F (50°C). Failure to do somay result in injury to death to peronnel.d. If grommet (1) is clogged or dirty, removeand clean with dry cleaning solvent andclean rag.e. Install vent grommet (1) in fuel cap (2).Make sure it is properly seated.WARNINGAir pressure in excess of 30psi (207 kPa) can injure per-sonnel. Do not direct pres-surized air at hourself orothers. Always wear gog-gles.f. Clean screen cap (3) with dry cleaningsolvent. Dry with compessed air.g. Install screen cap (3) in fuel cap (2).solvent. Dry with compessed air.4.5.6.7.While holding one end of spring plate (4),place other end in groove in filler neck (5). Rotate spring plate and install in filler neck.Install hook (6) with attached chain (7) andfuel cap (2) to spring plate (4).Install fuel cap (2), with attached chain (7)in filler neck (5).Close fuel filter combat cover (8).END OF TASK6-48.2Change 2
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business