STE/ICE-R TEST 72 STARTER CURRENT (FIRST PEAK)

STE/ICE-R TEST 73 BATTERY RESISTANCE - STE/ICE-R TEST 75 BATTERY RESISTANCE CHANGE (PACK)

TM-9-2350-261-20-1 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
610

TM 9-2350-261-20-1 STE/ICE-R TEST 72 STARTER CURRENT (FIRST PEAK) INITIAL SETUP Tools: STE/ICE-R Test Set (Item 71.1, App D) Personnel Required: Unit Mechanic References: See your -10 TM 9-4910-571-12&P Equipment Conditions: Engine stopped (see your -10) Carrier blocked (see your -10) All electrical accessories turned off (see your -10) Fuel OFF, engine must not start (see your -10) STE/ICE-R power hooked up (page 3-275) STE/ICE-R starter circuit test hooked up (page 3-279) 1. Select TEST 72. DISPLAY PERFORM/RESULT 2. Perform offset test. a. OFF Stop cranking and wait for message to appear. a. Press and hold TEST button until CAL b. c . appears. Release TEST button. If VTM reads between -225 and +225, offset test passes. If offset test fails, see TM 9-4910-571-12&P. b. A number c. .9.9.9.9 CIRCUIT RESISTANCE (in amps) Beyond range of VTM, cannot be measured. 3. Press and release TEST button. d. Error message See see page 3-242. 4. When GO appears, turn MASTER SWITCH to ON and crank engine for 2 seconds or 5. Turn MASTER SWITCH to OFF. until one of the following appears on VTM: 6. Observe VTM reading. a. If VTM reading is between 700 and 1275, test passes. b. If reading is erratic or cannot be obtained, see TM 9-4910-571-12&P. 7. Return to troubleshooting. END OF TASK 3-290 Change 4

Privacy Statement
Press Release
Contact