STE/ICE-R TEST 74 STARTER CIRCUIT RESISTANCE CONT.

STE/ICE-R TEST 73 BATTERY RESISTANCE - STE/ICE-R TEST 75 BATTERY RESISTANCE CHANGE (PACK) CONT.

STE/ICE-R TEST 90 DC CURRENT 0 TO 1500 AMPS

TM-9-2350-261-20-1 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
613

TM 9-2350-261-20-1 STE/ICE-R TEST 74 STARTER CIRCUIT RESISTANCE INITIAL SETUP Tools: STE/ICE-R Test Set (Item 71.1, App D) Personnel Required: Equipment Conditions: Engine stopped (see your -10) Carrier blocked (see your -10) All electrical accessories turned off Unit Mechanic (see your -10) Fuel OFF, engine must not start (see your -10) STE/ICE-R power booked up (page 3-275) STE/ICE-R starter circuit test hooked up (page 3-279) References: See your -10 TM 9-4910-571-12&P 1. Select TEST 74. DISPLAY PERFORM/RESULT 2. Perform offset test. c. Press and hold TEST button until CAL appears. Release TEST button. If VTM read6 between -225 and +225, offset test passes. If offset test fails, see TM 9-4910-571-12&P. a. OFF a. b. b. A number c. .9.9.9.9 Stop cranking and wait for message to appear. CIRCUIT RESISTANCE (in milliohms) Beyond range of VTM, cannot be measured. 3. Press and release TEST button. d. Error message See page 3-242 4. When GO appears, turn MASTER SWITCH to ON and crank engine for 5 seconds or 5. Turn MASTER SWITCH to OFF. until one of the following appears on VTM: 6. Observe VTM reading. a. If VTM reading is between 5 and 27, test passes. b. If reading is erratic or cannot be obtained, see TM 9-4910-571-12&P. 7. Return to troubleshooting. END OF TASK Change 4 3-293

Privacy Statement
Press Release
Contact