POWER CONTROL ENCLOSURE A1 DC INPUT/OUTPUT INOPERATIVE ....CONT.

POWER CONTROL ENCLOSURE A1 DC INPUT/OUTPUT INOPERATIVE ....CONT. - TM-9-2350-261-20-1_445

POWER CONTROL ENCLOSURE A1 DC INPUT/OUTPUT INOPERATIVE ....CONT. - TM-9-2350-261-20-1_447

TM-9-2350-261-20-1 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
416

TM 9-2350-261-20-1 1. 2. 3. 4. 5. 6. Set MASTER SWITCH to OFF (see your -10). Install cable W38 plug P7 (1) on Power Control Enclosure jack J28 (2). Remove circuit 415 plug P1 (3) from adapter T2 plug P1 (4). Set MASTER SWITCH to ON (see your -10). Measure voltage between circuit 415 plug P1 (3) and ground. Does multimeter read 22 volts DC or more? 1. 2. 3. 4. Set MASTER SWITCH to OFF (see your -10). Remove cable W29 plug P1 (1) from adapter T2 plug P2 (2). — Measure resistance between adapter T2 plugs P2 (2) and P1 (3). Does multimeter read 0 ohms? GO TO NEXT PAGE 1. Go to: MASTER SWITCH ON indicator does not light (page 3-129). 1. Replace adapter T2 (page 40.1-84). 2. Verify no faults found. Change 3 3-226.11

Privacy Statement
Press Release
Contact