TM 9-2350-261-20-1
1.
2.
3.
4.
5.
Turn all vehicle power OFF (see your -10 and
TM 11-7010-256-12&P).
Remove ten screws (1) and lockwashers (2), and lower
faceplate (3). Discard lockwashers.
Set MASTER SWITCH to ON (see your -10).
Measure voltage between positive (4) and negative (5)
terminals on meter M2 (6).
Does multimeter read 22 volts DC or more, and the
same as meter M2?
1. Raise faceplate (1) and secure to Power Control Enclo-
sure with ten new lockwashers (2) and screws (3).
2. Verify no faults found.
1. Adjust meter M2 needle to
match multimeter reading.
2. If meter cannot be adjusted,
replace DC meter M2
(page 40.1-29).
3. Verify no faults found.
3-226.10
Change 3
