TM 9-2350-261-20-1
1.
2.
3.
4.
Remove eight nuts (1), washers (2), and screws (3)
from master switch panel (4). Pull panel away
from distribution box (5).
Remove circuit 10 and 37A plugs (6 and 7) from
circuit breaker jacks (8 and 9).
Measure resistance between circuit breaker jacks
(8 and 9).
Does multimeter read 0 ohms?
1. Turn MASTER SWITCH to ON.
2. Measure voltage at circuit 10 plug.
3. Does multimeter read less than 17 volts?
1. Replace circuit breaker
(page 17-11).
2. Verify no faults found.
1. Turn MASTER SWITCH
to OFF.
2. Repair rear main wiring
harness circuit 37A
(page 14-3).
3. Verify no faults found.
1. Turn MASTER SWITCH to OFF.
2. Repair circuit 10 in master switch panel from the
bus bar to the circuit breaker (page 14-3).
3. Verify no faults found.
3-123