TM 9-2350-261-20-1
1. Install engine harness plug C8 on generator jack.
2. Remove engine wiring harness plug C3 (1) from
bulkhead jack (2) and plug C4 (3) from regulator jack
C4 (4).
3. Inspect engine harness plug C3 (1), bulkhead jack (2),
front main plug C4 (3) and regulator jack C4 (4) for
corrosion and damage.
4. Is plug and jack in clean and good condition?
1. Repair/replace front main
wiring harness and/or
regulator (pages 14-3
and 9-40).
2. Verify no faults found.
1. Measure resistance between front main harness
bulkhead jack (1) and front main plug C4 (2), sockets B
(3) to pins B (4), C (5) to C (6), D (7) to D (8), and E (9)
to E (10).
2. Does multimeter read 0 ohms each time?
GO TO NEXT PAGE
1. Repair/Replace Front Main
Harness (page 14-3).
2. Verify no faults found.
Change 4
3-57