TM 9-2350-261-20-1
1. Remove jumper wire from engine harness plug.
2. Install engine wiring harness on generator field switch.
3. Turn MASTER SWITCH to ON.
4. Measure voltage between front main harness bulkhead
jack C7 (1) pin F (2) to ground.
5. Turn MASTER SWITCH to OFF.
6. Did multimeter read more than 17 volts?
1. Repair front main wiring harness circuit 1B
(page 14-3).
2. Verify no faults found.
1. Engine stopped/shutdown (see your -10).
2. Measure resistancebetween regulator housing (1) and
ground.
3. Does multimeter read 0 ohms?
1. Install front main harness
plug C5 on regulator jack.
2. Repair front main wiring
harness circuit 1A
(page 14-3).
3. Verify no faults found.
1. Remove regulator
(page 9-40) and clean
ground contacts
(bolted surface).
2. Install regulator.
3. Verify no faults found.
GO TO NEXT PAGE
Change 4
3-61
