Remove mud and debris from
bilge pump and screen. If bilge
pump needs additional cleaning,
notify unit maintenance.
5.
6.
Clean vent hole. Use a wire and
run it back and forth in vent
hole a few times.
Install rear floor plate on floor
supports and secure with six
washers and screws. Use 1/2
inch drive socket wrench handle
and 3/4 inch socket .
7. Raise ramp (page 2-153).
TM 9-2350-261-10
BILGE PUMPS OPERATION
CHECK
1. Move MASTER SWITCH to ON.
2. Move BILGE PUMPS switch to
ON.
GO TO NEXT PAGE
3-41
