9-2350-261-10
10.
11.
Position bilge pump screen on
weld nuts and secure with two
flat washers, lockwashers and
screws. Use cross tip
screwdriver.
Connect lead to bilge pump.
13. Close power plant access door
(page 2-151).
14. Stow trim vane (page 2-217).
R E A R B I L G E P U MP
2.
Lower ramp (page 2-153).
Remove six screws, washers and
rear floor plate from floor
supports. Use 1/2 inch drive
socket wrench handle and 3/4
inch socket.
12. Install front access cover on hull
and secure with four washers
and screws. Use 1/2 inch drive
socket wrench handle and 3/4
inch socket.
3. Service rear bilge pump. Use
flashlight.
3-40
T M
1.