TM 9-2350-261-10
13. Disconnect track. Use crowbar
to break track apart.
CAUTION
Track pin threads are easily
damaged. Do not force track pin.
Tap track pin lightly with ham-
mer.
NOTE
If track is difficult to join, step 7
can he repeated to release more
t r a c k t e n s i o n . A s t r a c k p in
moves through track hole, track
pin will push drift pin out ahead
of it.
1.
2.
Install two track fixtures across
place where track is to be
connected. Install track fixture on
outside track first. Use 1-5/16
inch open end wrench.
Move ends of track together with
crowbar.
3. Coat the track pin with oil or
grease. Install a nut flush with
one end of the pin.
WARNING
Always wear eye
p r o t e c t i o n w h e n
using a hammer.
Eye injury may re-
suit if metal chips
contact eyes
4. Tighten each track fixture an
equal amount to line up track
pin holes. Tap long end of chive
pin punch through track pin holes
to other side of track. Use
hammer. Tighten track fixture as
needed to obtain 20 degree angle
between shoes to be connected.
Use 1-5/16 inch open end
wrench.
GO TO NEXT PAGE
Change
5
3-27
