TM 9-2350-247-20-3
REPLACE BEAM/BEAM SUPPORTS/STOPS
0483 00
THIS WORK PACKAGE COVERS:
Removal (page 0483 00-1).
Disassembly (page 0483 00-2).
Assembly (page 0483 00-2).
Installation (page 0483 00-3).
INITIAL SETUP:
Maintenance Level
Unit
Tools and Special Tools
General Mechanic’s Tool Kit (WP 0541 00, Item 57)
Materials/Parts
Lock nut
Lock washer (2)
Personnel Required
Unit Mechanic
Helper (H)
References
See your -10
Equipment Condition
Engine stopped (see your -10)
Carrier blocked (see your -10)
Hoist removed (WP 0484 00)
REMOVAL
NOTE
There are two beam supports. They are each removed and installed the same way.
1.
Remove screw (1), lock nut (2), and two center stops (3) from beam (4). Discard lock nut.
NOTE
Beams are heavy and awkward. Use helper to remove and install beams.
2.
Loosen beam lock (5) on each beam support (6). Slide beam (4) out of supports.
3.
Turn retaining pin handle (7) of retaining pin (8) up and pull pin from beam support (6). Remove support from bolt-on
bow support (9).
0483 00-1
