TM 9-2350-247-20-3REPLACE BEAM/BEAM SUPPORTS/STOPS — Continued 0483 00INSTALLATIONNOTEBend or close S-hooks so they will not interfere with pin removal and installation.1. Place beam support (4) on bolt-on bow support (13). Secure with retaining pin (12).NOTEBeams can be placed in several positions. If beam is to be angled, one beam support must be atcenter of bolt-on bow support (see your -10).2. Install beam (14) on two beam supports (4). Tighten beam locks (3).CAUTIONWhen you install beam, make sure center stops are in front of rear beam support and beamlocks are toward front.NOTETo prepare hoist and beam for travel, see your -10.3. Install two center stops (15) at each beam support (4) with screw (16) and new lock nut (17).FOLLOW-THROUGH STEPS1. Install hoist (WP 0484 00).END OF TASK0483 00-3/4 blank
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
