TM 9-2350-247-20-2
REPLACE AUXILIARY POWER (SLAVE) RECEPTACLE
THIS WORK PACKAGE COVERS:
Removal (page 0303 00-1).
Installation (page 0303 00-3).
INITIAL SETUP:
Personnel Required
Maintenance Level
Unit Mechanic
Unit
References
Tools and Special Tools
See your -10
General Mechanic's Tool Kit (WP 0541 00, Item 57)
Socket Wrench (WP 0541 00, Item 64)
Equipment Condition
Materials/Parts
Engine stopped (see your -10)
Carrier blocked (see your -10)
Gasket
Drivers seat raised (see your -10)
Lock nut (4)
Battery negative lead(s) disconnected (WP 0292 00)
Lock washer (2)
Lock washer (4)
REMOVAL
NOTE
Steps 1 - 3 tell you how to remove the early model auxiliary power receptacles. Steps 4 - 8 tell
you how to remove the late model auxiliary power receptacles.
1.
Remove nut (1). Remove auxiliary power receptacle ground lead (2) from bulkhead (3).
2.
Remove nut (4) from screw (5). Remove screw (5) and auxiliary power receptacle circuit 49 lead (6) from bus bar (7).
Remove four nuts (8) from screws (9). Remove auxiliary power receptacle (10) from bulkhead (3).
3.
Change 1
