TM 9-2350-247-20-2
THIS WORK PACKAGE COVERS:
INITIAL SETUP:
Maintenance Level
References
See your -10
Unit
Equipment Condition
Tools and Special Tools
Engine stopped (see your -10)
General Mechanic's Tool Kit (WP 0541 00, Item 57)
Carrier blocked (see your -10)
Personnel Required
Driver's seat raised (see your -10)
Unit Mechanic
Center seat raised (see your -10)
REMOVAL
1.
Remove nut (1), two washers (2), and circuit 3 lead (3) from top terminal of circuit breaker (4).
2.
Remove nut (5), two washers (6), and circuit breaker ground lead (7) from bottom terminal of circuit breaker (4).
3.
Remove two nuts (8) and cap screws (9) from circuit breaker (4) and bulkhead. Remove circuit breaker from bulkhead.
INSTALLATION
1.
Place circuit breaker (4) on bulkhead. Secure with two caps screws (9) and nuts (8).
2.
Connect circuit breaker ground lead (7) to bottom terminal of circuit breaker (4). Secure with two washers (6) and
nut (5).
3.
Connect circuit 3 lead (3) on top terminal of circuit breaker (4). Secure with two washers (2) and
nut (1).
