TM 9-2350-247-20-1
REPLACE ENGINE OIL FILTER ASSEMBLY (M548A1) — Continued
0145 00
INSTALLATION
1.
Clean external threads of elbow (1) and elbow (2) with cleaning compound.
2.
Apply a thin even coat of sealing compound primer and sealing compound to cleaned external threads of elbow (1) and
elbow (2) before installation.
NOTE
Washers (6) are used on the two top screws only.
3.
Install oil filter assembly (3) on bracket (4) with four screws (5), two washers (6), and four nuts (7).
4.
Install bushing (8) and sampling valve (9) on oil filter assembly (3).
5.
Install elbow (1) and elbow (2) on oil filter assembly (3).
6.
Install oil hose (10) and oil hose (11) on elbow (1) and elbow (2).
7.
Install drain plug (12) in oil filter assembly (3)
.
8.
Add engine oil (WP 0128 00).
FOLLOW-THROUGH STEPS
1.
Connect battery negative lead (WP 0292 00).
2.
Start engine (see your -10).
3.
Check filter assembly for leaks.
4.
Stop engine (see your -10). Wait about 20 minutes for engine oil to drain back to pan. Then check oil level. Add oil if
needed (WP 0128 00).
5.
Install top access cover and grilles (WP 0390 00).
6.
Install power plant right rear access cover (see your -10).
END OF TASK
0145 00-3/4 blank
