STE/ICE-R LOW OIL PRESSURE TROUBLESHOOTING

STE/ICE-R STARTER CIRCUIT TROUBLESHOOTINGContinued - TM-9-2350-247-20-1_536

STE/ICE-R LOW OIL PRESSURE TROUBLESHOOTINGContinued

TM-9-2350-247-20-1 Crane (CAB) Components Recovery Vehicle Full Tracked: light Armored M578 (2360-00-439-6242) (EIC:3LA) Manual
Page Navigation
443

TM 9-2350-247-20-1 STE/ICE-R LOW OIL PRESSURE TROUBLESHOOTING 0110 00 INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0541 00, Item 57) STE/ICE-R Test Set (WP 0541 00, Item 6) Personnel Required Unit Mechanic References See your -10 TM 9-4910-571-12&P (WP 0046 00) Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) Center seat raised (see your -10) STE/ICE-R hooked up for power (WP 0114 00) STE/ICE-R engine RPM test hooked up (WP 0115 00) T 1. Remove oil pressure sending unit (1) from engine. 2. Install blue striped pressure transducer (2) in place of oil pressure sending unit (1). 3. Connect transducer cable W4P1 (3) to J3 (4) on VTM. 4. Connect transducer cable W4P2 (5) to blue striped pressure transducer (2). 5. Set test select switches to 50. 6. Press and hold test button until CAL appears on display. 7. Is offset value within -150 to + 150? YES NO TN 1. Go to offset fault isolation. See TM 9-4910-571-12&P. 2. Verify no faults found. 0110 00-1

Privacy Statement
Press Release
Contact