TM 9-2350-287-20-18-2. SHIFT CONTROL LINKAGE REPAIR (continued).12.Remove spring pin (72), hollow pin (73), and bellcrank (71) from control assembly (24). Discard spring pin.WARNINGUse care when removing spring. Spring is under tension; it can act as a projectilewhen released and cause severe eye injury.13.Remove spring pin (74), spring (75), and pin (76) from bellcrank (71). Discard spring pin.c.CLEANING AND INSPECTION1.Clean rod end bearings.WARNINGDrycleaning solvent P-D-680 is toxic and flammable. Always wear protectivegoggles and gloves, and use only in a well-ventilated area. Avoid contact withskin, eyes, and clothes, and DO NOT use near open flame or excessive heat.2.Clean all remaining metal parts with drycleaning solvent.3.Inspect all parts for damage or excessive wear. Replace any damaged or worn parts.Change 1 8-8
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
