3-4. SHOCK MOUNT AND BRACKET REPLACEMENT.

FOLLOW-ON MAINTENANCE - TM-9-2350-287-20-1_532

b. INSTALLATION - TM-9-2350-287-20-1_534

TM-9-2350-287-20-1 Carrier Ammunition Tracked M992A21 (2350-01-352-3021) EIC:AE6 Manual
Page Navigation
509

TM 9-2350-287-20-1 3-4. SHOCK MOUNT AND BRACKET REPLACEMENT. This Task Covers: a. Removal b. Installation Initial Setup: Tools/Test Equipment: Self-locking nut (Item 326, Appendix H) General mechanic's tool kit Self-locking screw (8) (Item 335, Appendix H) (Item 24, Appendix I) Torque wrench (0-175 ft-lb) Equipment Conditions: (Item 69, Appendix I) Vehicle parked on level ground (refer to TM 9-2350-287-10). Materials/Parts: · Powerpack removed (para 3-2). Lockwasher (3) (Item 177, Appendix H) [Equipment Condition Deleted] Lockwasher (2) (Item 180, Appendix H) a. REMOVAL WARNING Engine must be properly supported before removing shock mount. Failure to provide proper support can result in injury to personnel or equipment damage. 1. Remove self-locking nut (1) and shock mount (7), with two engine shock mount plates (6) attached, from bracket (2). Discard self-locking nut. 2. Remove two screws (3) and lockwashers (4) fromshock mount (7). Discard lockwashers. 3. Separate two engine shock mount plates (6), spacer plate (5), spacer sleeve (10), washer (9), and screw (8) from shock mount (7). 4. Remove three screws (12) and lockwashers (13) from bracket (2). Discard lockwashers. 5. Remove eight self-locking screws (11) and bracket (2) from engine. Discard self-locking screws. Change 1 3-36

Privacy Statement
Press Release
Contact