TM 9-2350-287-20-1
3-3. GROUND HOP PROCEDURES (continued).
8.
9.
10.
11.
12.
13.
14.
15.
NOTE
If a vehicle is being used that already has a powerpack installed, wiring harnesses will have
to be connected to the engine disconnect bracket, starter protection relay electrical lead, and
top terminal of the rectifier after disconnecting power cable assemblies in steps 6 through 12.
Disconnect starter protection electrical lead 503 (39) from electrical lead 403 (40).
Disconnect power cable assembly 12268426 (30) from wiring harness 12268308 connector (38).
Disconnect power cable assembly 12268162 (32) from wiring harness 12268414-1 connector (34).
Disconnect power cable assembly 12268427 (33) from wiring harness 12353401 connector (32).
Disconnect power cable assembly (36) from wiring harness 12329994 connector (37).
Disconnect starter protection relay electrical lead 503 (31) from power cable assembly 12268426 (30).
Disconnect cable assembly (30) from rectifier (29).
NOTE
Perform steps 15 through 17 only if the vehicle being used to operate the powerpack
is the one from which the powerpack was removed.
Disconnect wiring harness 12376406 connector (28) from rectifier (29).
3-31
