TM 9-2350-287-20-1
2-22. SIMPLIFIED TEST EQUIPMENT FOR INTERNAL COMBUSTION
ENGINES (STE/ICE).
a. STE/ICE PMCS - (continued).
(1) VTM CONNECTIONS AND CHECKOUT FOR DCA.
I
WARNING
To prevent personal injury, do not
connect or disconnect VTM while
engine is running.
I
CAUTION
I
Connect connector P1 of DCA cable
W1 to J1 on the VTM before
connecting to the diagnostic
connector.
Connect battery to VTM:
1. Pull VTM power switch to the OFF position.
2. Connect DCA cable WI connector P1 to VTM
connector J1.
3. Connect DCA cable W1 connector P2 to
harness W100 connector P4 DCA receptacle.
4. Make sure all connections are correct and
tightened.
NOTE
Place the VTM so only its rubber feet touch
the vehicle ordo all testing with the MASTER
switch ON. This will prevent sparking during
testing. Sparking will interrupt testing, but
will not damage the VTM.
A. 1. Push power switch on VTM to ON position.
2. Make sure VTM display shows 8.8.8.8 for
two seconds and then changes to- ---.
Does VTM display show 8.8.8.8 and then change to
. . . . .?
,,
Continued on next page
2-381